You can use the management console to
make changes to the network interface settings after the initial deployment.
You can configure the host name, the IPv4 addresses of the Deep Discovery Web
Inspector appliance, and
other network settings.
![]() |
NoteAs part of the
configuration, you can enable LACP and use trunked interfaces for data ingress and
data egress. To deploy LACP link aggregation for Transparent Bridge or Transparent
HA modes, the appliance must be equipped with two bypass cards. You must configure
the connected switches with the corresponding LACP configuration.
|
Procedure
- Go to .
- Specify the general network settings that affect all
interfaces.OptionDescriptionHost nameSpecify the host name.GatewaySpecify the IPv4 address of the gateway.
Primary DNS server and Secondary DNS server Specify the IPv4 addresses of the primary DNS server and optionally, the secondary DNS server. - Specify the IPv4 address and subnet mask for the
eth0
port:Theeth0
interface handles management console traffic, SSH connections, Trend Micro updates, and other related Trend Micro traffic.eth0
is known as the:- Data and Management interface for the Forward Proxy deployment mode by default
- Management interface for the Transparent Bridge deployment mode
- Management interface for the Transparent HA deployment mode
- Specify the IPv4 address and subnet mask for the
eth1
port if you plan on using a custom network for Virtual Analyzer sandbox instances to connect to the Internet.Theeth1
interface is known as the dirty line port for Virtual Analyzer custom network connections. If Custom network is selected when configuring Virtual Analyzer network connections, Virtual Analyzer connects to the Internet usingeth1
, which is isolated from the management network. - Specify the IPv4 address and subnet mask for other Ethernet interface ports
that you will use in your deployment.The available ports will vary depending on the deployment mode and your particular deployment.
Deployment Mode Port Information Forward Proxy-
eth4: Dedicated interface for Authentication/Proxy service
-
Hide the configurations of unused network ports (eth2, eth3 and eth5)
You can configure eth4 with static IP address.Transparent Bridge-
eth2
: Dedicated interface for Authentication service -
eth4
: Designated as eth4 — Data Ingress Port -
eth5
: Designated as eth5 — Data Egress Port -
Hide the configuration of unused network port (eth3)
Transparent HA-
eth2
: Dedicated interface for Authentication service -
eth4
: Designated as eth4 — Data Ingress Port -
eth5
: Designated as eth5 — Data Egress Port -
Hide the configuration of unused network port (eth3)
For Transparent HA, you can modify thebr0
IP address and VLAN tag.Transparent Bridge with LACP trunks-
eth2
: Dedicated interface for Authentication service -
eth4
/eth6
: Teamed to become the team0 interface -
eth5
/eth7
: Teamed to become the team1 interface -
Hide the configuration of unused network port (eth3)
The teamed interfaces are used for data ingress/data egress.Transparent HA with LACP trunks-
eth2
: Dedicated interface for Authentication service -
eth4
/eth6
: Teamed to become the team0 interface -
eth5
/eth7
: Teamed to become the team1 interface -
Hide the configuration of unused network port (eth3)
The teamed interfaces are used for data ingress/data egress.You can modify thebr0
IP address and VLAN tag. -
- Click Save.When you save network changes, network services are restarted. After the restart, you must log on to the console again.