Enabling and Starting the SSH Service | Trend Micro Service Central

You’re offline. This is a read only version of the page.

Views:

By default, the SSH service is disabled and is not started when enabled. You must use the command line interface to first enable and then start the SSH service.

Procedure

To enable and start the SSH service, first enter the CLI.

Entering the CLI.
Enable the SSH service.
configure service ssh enable
Start the SSH service.
start service ssh

Keywords: enabling and starting,SSH service,enabling and starting service,enabling and starting SSH service

Table of Contents

The page you're looking for can't be found or is under maintenance

Try again later or go back to the previous page

Go back