Deep Discovery Web
Inspector is a hardware
appliance with all software pre-installed. It is ready to deploy on your network as
shipped from the manufacturer.
The following table lists the minimum software requirements to access
the command line interface and the web management console that are used to manage
Deep Discovery Web
Inspector. Before
deployment, you should review the list and ensure that you can meet the browser and
SSH client software requirements.
Minimum Software Requirements
|
Application
|
Requirements
|
Details
|
|
SSH client
|
SSH protocol version 2
|
Set the Command Line Interface terminal window size
to 80 columns and 24 rows.
|
|
Microsoft Internet Explorer
|
Version 11
|
Use only a supported browser to access the management
console.
Using the data port IP address you set during the
initial configuration, specify the following URL:
https://[Appliance_IP_Address] |
|
Microsoft Edge
|
Windows 10
|
|
|
Mozilla® Firefox®
|
Version 70 or later
|
|
|
Google Chrome™
|
Version 78 or later
|
|
|
Mac® Safari®
|
Mac OS 12.0.3 or later
|
-
Trend Micro recommends viewing the console using a monitor that supports 1280 x 1024 resolution or greater.
-
By default, the SSH service is disabled and is not started when enabled. To use SSH, you must first enable and then start the SSH service.
-
Make sure that the management interface eth0 (on the back of the appliance) is accessible via TCP port 22 for the Command Line Interface (SSH) and TCP port 443 for the management console (HTTPS).