You can configure
Transparent HA mode with trunk links. You should be aware of certain requirements
and the
topology for this deployment mode.
You can create trunk links using LACP port aggregation in environments where
higher bandwidth for data ingress and data egress is required. When LACP is enabled,
Deep Discovery Web
Inspector automatically creates a
two-port trunk for data ingress and a two-port trunk for data egress on each of the
two HA
nodes.
Topology

Requirements
You should understand the following requirements that are dependent on how Deep Discovery Web
Inspector IP addressing works under
various scenarios for VLAN trunk links including the following:
- How IP addressing works under the native VLAN of the trunk link:
Case 1: Traffic under the native VLAN going out of the switch to Deep Discovery Web Inspector does not carry the native VLAN ID.Requirement: When performing the initial deployment, you should disable the VLAN ID on the egress port.Case 2: Traffic under the native VLAN going out of the switch to Deep Discovery Web Inspector carries the native VLAN ID.Requirement: When performing the initial deployment, you should enable the VLAN ID on the egress port, and the VLAN ID must set to the native VLAN ID.
- How IP addressing works under a normal trunk VLAN.
Requirement: When performing the initial deployment, you should enable the VLAN ID on the egress port, and the VLAN ID must set to the normal trunk VLAN ID.
![]() |
Important
|