Views:
With the SNMP trap response action you can use SNMP trap notification for Active Responder events. This action sends an SNMP Trap to an SNMP agent (SNMP version 2 or 3).

Procedure

  1. Review Create or edit a response action.
  2. Select SNMPTrap from the Action Type list.
  3. Click Trap Destination (or click Next), and then enter the following information:
    Note
    Note
    An SNMP trap receiving agent must be running on the destination port configured for this action when you implement the action.
    • Specify the trap destination Host and Port settings.
    • Select whether you want the SMS to send a trap when the action is closed.
  4. Click SNMP Settings (or click Next), and then enter the following information:
    • SNMP Version — Version of SNMP to use when sending this trap.
    • Community — Group to which the destination host belongs. Only valid for SNMP v2.
    • Engine ID — Numeric ID that identifies this trap.
    • User Name — User login name to use for authentication. Defaults to private for a v3 trap. Value is only used for SNMP v3.
    • Authentication Protocol — Protocol to use for authentication. Only valid for SNMP v3.
    • Authentication Key — User login password to use for authentication. Only valid for SNMP v3.
    • Privacy Protocol — Protocol to use for data protection. Only valid for SNMP v3.
    • Privacy Key — Password to use for encrypting the trap. If no value is specified, the trap is not encrypted. Only valid for SNMP v3.
    Important
    Important
    To implement this action, add it to the Actions section of an Active Responder policy that is added to an action set enabled for SMS Response.