For Deep Discovery Email Inspector appliances that do not include an optical drive, you can install Deep Discovery Email Inspector through the iDRAC (Integrated Dell Remote Access Controller) port.
WARNING
WARNING
The installation deletes any existing data or partitions on the selected disk. Back up existing data before installing Deep Discovery Email Inspector.

Procedure

  1. Download the Deep Discovery Email Inspector installation ISO file from the License screen on the Business Success Portal at https://success.trendmicro.com/dcx/s/license.
  2. Configure the iDRAC IP address. Do the following:
    1. If the appliance is turned on, power off the appliance.
    2. Connect the iDRAC port on the Deep Discovery Email Inspector appliance to a DHCP-enabled network.
    3. Connect a monitor to the VGA port and attach a keyboard to a USB port on the appliance.
    4. Power on or restart the appliance.
      Note
      Note
      The power button is found on the front panel of the appliance, behind the bezel.
    5. When the power-on self-test (POST) screen appears, press F2 to go to System Setup.
    6. Select iDRAC Settings → Connectivity → Network.
    7. In the IPv4 Settings section, disable DHCP and configure the required settings for the appliance to use a static IP address.
    8. Click Apply to save the changes.
  3. Log into the iDRAC interface. Do the following:
    1. Open a web browser and go to the following address:
      https://<idrac_ip_address>
      The iDRAC login screen appears.
    2. Specify the login credentials and click Log In.
      The Dashboard appears.
  4. Turn off the appliance. On the Dashboard, select Power Off System from the Graceful Shutdown drop-down list.
  5. Click Start Virtual Console.
    A console screen appears.
  6. Click Boot and select Virtual CD/DVD/ISO.
  7. Click Virtual Media and select Connect Virtual Media; then, click Connect Virtual Media.
  8. Under Map CD/DVD, click Choose File to select the Deep Discovery Email Inspector installation ISO file and click Map Device.
    The system indicates the device is mapped successfully.
  9. On the Dashboard, click Power On System.
    Wait until the Deep Discovery Email Inspector Appliance Installation screen appears.
  10. Select 1. Install Appliance and press ENTER.
    • When installing Deep Discovery Email Inspector via serial port, select 2. Install Appliance via Serial Port and press ENTER.
    The License Agreement screen appears.
  11. Click Accept.
  12. Select the device to install Deep Discovery Email Inspector.
  13. Click Continue.
  14. At the warning message, click Yes to continue.
    The Deep Discovery Email Inspector installer scans the hardware to determine that it meets the minimum specifications.
  15. Click Next.
    The Summary screen appears.
  16. Click Continue to begin the installation.
  17. At the warning message, click Continue.
    After formatting the disk, the program installs the operating system. The Deep Discovery Email Inspector appliance installs after the appliance restarts.
  18. Configure network settings to access the management console.
    For details, see Configuring Management Console Access.
  19. Open the management console.
    For details, see The Management Console.
    For information about configuring Deep Discovery Email Inspector, see the Deep Discovery Email Inspector Administrator's Guide.