From the Deep Discovery Director - Network Analytics (the appliance) preconfiguration console, you can use the following controls:
  • Press TAB to navigate to menu items and fields.
  • Press ENTER to make a selection.

Procedure

  1. Open the appliance's virtual machine console.
  2. Log on to the preconfiguration console:
    Default user name and password:
    • User name: admin
    • Password: admin
    The Main Menu screen appears.
  3. Go to Network Configuration → Configure Management Interface.
  4. Configure and save the following required settings:
    • IPv4 address
    • Subnet mask
    • IPv4 gateway
    Note
    Note
    The eth0 interface is preselected. You can configure only IPv4 settings on this interface.
    The Network Configuration screen appears after the settings are successfully saved.
  5. Go to Configure Hostname and DNS Settings.
  6. Configure and save the following settings:
    • Hostname
      Specify either as a host name or a FQDN.
    • Primary DNS Server
    • (Optional) Secondary DNS Server
    • (Optional) Tertiary DNS Server
    • (Optional) Search Order
    The Network Configuration screen appears after the settings are successfully saved.
  7. Use the Back button to navigate back to the main menu.
  8. (Optional) From the main menu, go to Change Admin Password and then press ENTER.
    Trend Micro recommends that you change the admin password.
    The Linux Change Password prompt appears.
  9. Change the admin password.
    The Main Menu screen appears after the password is successfully changed.
After configuring network settings, you can use the preconfiguration console to register the appliance to Deep Discovery Director.
Registering to Deep Discovery Director