For Deep Discovery Analyzer appliances that do not include an optical drive and installation DVD, you can install Deep Discovery Analyzer through the iDRAC (Integrated Dell Remote Access Controller) port.
WARNING
WARNING
The installation deletes any existing data or partitions on the selected disk. Back up existing data before installing Deep Discovery Analyzer.

Procedure

  1. Download the Deep Discovery Analyzer installation ISO file from the License screen on the Business Success Portal at https://success.trendmicro.com/dcx/s/license.
  2. Connect a computer to the iDRAC port on the Deep Discovery Analyzer appliance. Do the following:
    1. If the appliance is turned on, power off the appliance.
    2. Configure the computer to use a static IP address in the network segment 192.168.252.x/24.
      Important
      Important
      Do not use the reserved IP addresses 192.168.252.1 and 192.168.252.3.
      Note
      Note
      The iDRAC port on the Deep Discovery Analyzer appliance uses the following default network settings:
      • IP address: 192.168.252.3
      • Gateway: 192.168.252.1
      • Subnet: 255.255.255.0
    3. Connect a monitor to the VGA port and attach a keyboard to a USB port on the appliance.
    4. Power on the appliance.
      Note
      Note
      The power button is found on the front panel of the appliance, behind the bezel.
  3. Log into the iDRAC interface. Do the following:
    1. Open a web browser and go to the following address:
      https://192.168.252.3
      The iDRAC login screen appears.
    2. Specify the login credentials and click Log In.
      The Dashboard appears.
  4. Click Start Virtual Console.
    A console screen appears.
  5. Click Boot and select Virtual CD/DVD/ISO.
  6. Click Virtual Media and select Connect Virtual Media; then, click Connect Virtual Media.
  7. Under Map CD/DVD, click Choose File to select the Deep Discovery Analyzer installation ISO file and click Map Device.
    The system indicates the device is mapped successfully.
  8. On the Dashboard, click Power On System.
    Wait until the Deep Discovery Analyzer Appliance Installation screen appears.
  9. Select 1. Install Appliance and press ENTER.
    The License Agreement screen appears.
  10. Click Accept.
    The Select Disk screen appears.
  11. Select the disk on which to install the Deep Discovery Analyzer software.
  12. Click Continue.
    The program checks if the minimum hardware requirements are met, and then displays the Hardware Profile screen.
  13. Click Continue.
    WARNING
    WARNING
    Installation involves repartitioning of the disks. All data on the disks are lost.
    A confirmation message appears.
  14. Click Continue.
    The installation program repartitions the disks and prepares the environment for installation. Upon completion, the appliance is restarted and Deep Discovery Analyzer software is installed.
    Configure the IP address of the appliance on the preconfiguration console to complete the deployment process. For details, see Configuring Network Addresses on the Preconfiguration Console.