Run vulnerability scans on demand.
- Launch Vulnerability Scanner.
To Launch Vulnerability Scanner On:
Steps
The Security Server
Navigate to <Server installation folder>\PCCSRV\Admin\Utility\TMVS.
Double-click TMVS.exe.
A client on the network
On the Security Server, navigate to <Server installation folder>\PCCSRV\Admin\Utility.
Copy the TMVS folder to the other client.
On the other client, open the TMVS folder and then double-click TMVS.exe.
- Go to the Manual Scan section.
- Type the IP address range of the clients you want to
check.
- Type an IPv4 address range.
Note:
Vulnerability Scanner can only query an IPv4 address range if it runs on a pure IPv4 or dual-stack client. Vulnerability Scanner only supports a class B IP address range, for example, 168.212.1.1 to 168.212.254.254.
- For an IPv6 address range, type the IPv6 prefix and
length.
Note:
Vulnerability Scanner can only query an IPv6 address range if it runs on a pure IPv6 or dual-stack client.
- Type an IPv4 address range.
- Click Settings.
The Settings screen appears.
- Configure vulnerability scan settings. For details, see Vulnerability Scan Settings.
- Click OK.
The Settings screen closes.
- Click Start.
The vulnerability scan results appear in the Results table under the Manual Scan tab.
Note:MAC address information does not display in the Results table if the computer runs Windows Server 2008.
- To save the results to a comma-separated value (CSV) file, click Export, locate the folder where you want to save the file, type the file name, and click Save.