Configure network settings to allow Virtual Network Sensor to monitor data.
 |
NoteThe following instructions are valid as of October 2023.
These instructions are only for Virtual Network Sensors deployed on a KVM host
machine.
|
Before you begin, make sure you have prepared a vSwitch.
Procedure
- On the Virtual Network Sensor CLI console, type show
interface and choose a network interface that shows "Supported"
for Encapsulated Remote Mirroring.
- Execute the enable command.
- Execute the configure interface <network_interface> command.
- Execute the ip-encap enable [xxx.xxx.xxx.xxx] command.
- Type # exit to return to basic commands and verify that
the IP address is shown next to Encapsulated Remote Mirroring.
