Configure external network traffic with the VMware vSphere Distributed Switch using SPAN to allow Virtual Network Sensor to monitor data.
ImportantThe following instructions are valid as of July 2023.
|
NoteYou must use a vCenter administrator account.
|
Procedure
- Turn off your Virtual Network Sensor.
- On the VMware vCenter console, click the tab.
- Right-click the name of your data center, and go to .
- On the Name and location screen, specify the distributed
switch name and location and click NEXT.
- On the Select version screen, select your distributed
switch version and click NEXT.
- On the Configure settings screen, specify the number of
uplinks and click NEXT.
- On the Ready to complete screen, review the settings and
click FINISH.
- Right-click the name of your switch and select Add and Manage
Hosts....
- On the Select task screen, select Add
hosts and click NEXT.
- On the Select hosts screen, select your virtual machine
and click NEXT.
- On the Manage physical adapters screen, right-click the
name of your NIC and select Uplink 1.
- Click NEXT.
- On the Manage VMkernel adapters screen, click
NEXT.
- On the Migrate VM networking screen, click
NEXT.
- On the Ready to complete screen, click
FINISH.
- Click the name of your switch and then click the
Networks tab.
- Right-click the name of your port group and select Edit Settings....
- Click Security, select Accept for
promiscuous mode, and click OK.
- Click the tab and then click the name
of your virtual appliance.
- Click .
- On the Edit Settings screen, click Network
adapter 2 and select Browse....
- Click the name of your port group and click OK.
- Click OK.
- Turn on your Virtual Network Sensor.