Views:
Specify a list of alternate IP addresses so that managed devices separated from the SMS Server by a NAT layer can connect to the SMS through an address that resides on the same network as each device.

Procedure

  1. Go to Admin → Server Properties, and then select the NAT tab.
  2. Click Enable under SMS Per Network NAT.
    If Per Network NAT is enabled, the system consults the list of SMS NAT Addresses and chooses the entry whose network matches that of the specified device address. In case of multiple matches, the system chooses the most specific match. If no network address matches, the system consults the Global SMS NAT settings.
  3. Click Add.
  4. Enter the IP address for the device network.
  5. Enter the prefix length in bits. The Prefix Length is the number of bits that make up the network portion of the address. The maximum is 32 bits for an IPv4 address and 128 for an IPv6 address.
  6. Enter an SMS NAT Address that the device can use to connect to the SMS.
  7. Click OK.
  8. Click Apply.