Create or edit a security filter restriction or exception

You’re offline. This is a read only version of the page.

Views:

Select Profiles → Inspection Profiles → [Profile Name] → Security Filters.
Click the Restrictions or Exceptions tab, and then click either Add or Edit.
Enter the appropriate information in the Create/Edit Address Pair dialog.
Keep the following information in mind:
- Select Any IP to apply the restriction to all traffic sources/destinations.
- Select IP Address, and provide or select an IP address to apply the restriction to that specific source/destination.
Click OK.

Table of Contents

The page you're looking for can't be found or is under maintenance

Try again later or go back to the previous page