Create or edit an inspection bypass rule

Procedure

1. Select Devices → All Devices, select a device that supports inspection bypass, and then select Inspection Bypass.
2. Click New to create a new rule, or select an existing rule and click Edit.
3. In the Inspection Bypass Rule wizard, select Name from the left navigational menu.
4. Specify a Name for the exception rule and then indicate the desired Enabled status for the rule.
5. (TPS devices) Click Next or select Action from the wizard navigation pane to specify the Action to be performed on the traffic.
   For a description of the available actions, see Inspection bypass.
6. Click Next or select Protocol from the wizard navigation pane.
   • Select the Ethernet Type.
   • For IP Protocol, specify the Source/Destination ports and addresses.
7. Click Next or select VLAN from the wizard navigation pane. By default VLAN tag, MPLS label, or tunneling checks are NOT performed. To match all frames, do not select the VLAN check boxes.
8. Click Next or select Segments from the wizard navigation pane and then select the segments where the inspection bypass rule should be applied.

   Note For TX Series devices, the segments are listed by slot numbers.

9. Click Finish.