Views:
This feature is available on TPS devices (T Series, TX Series, and TXE Series). VLAN translation is not available on vTPS devices.

Procedure

  1. Select Devices → All Devices → device → Network Configuration.
  2. Click the VLAN Translation tab.
  3. Perform one of the following tasks:
    • To edit a VLAN Translation, select an entry from the table, and then click Edit.
    • To create a new VLAN Translation, click New.
  4. Enter the Incoming VLAN ID and Outgoing VLAN ID numbers from 1 to 4094.
  5. In the Port Selection area select the appropriate settings for each segment (1 to 11).
    Note
    Note
    The segments are grouped by slots. The segment lists the slot number and the segment number.
    • No mapping — Do not use mapping for selected segment.
    • A > B — For traffic arriving on side A with the specified Incoming VLAN ID, the VLAN ID is set to the specified Outgoing VLAN ID prior to leaving side B.
    • A < B — For traffic arriving on side B with the specified Incoming VLAN ID, the VLAN ID is set to the specified Outgoing VLAN ID prior to leaving side A.
    • Reverse mapping — Automatically creates an inverse mapping. Changes the VLAN ID for traffic in the reverse direction from the Outgoing value to the Incoming value.
  6. Click OK.