Configure network HA

Select Devices → All Devices → <device>, and then click Device Configuration.

Select HA (High Availability).

To configure Intrinsic HA, do one of the following:

Select Normal to override all Intrinsic HA settings and configure the device to inspect traffic according to the TSE settings.
Select Fallback to permit or block all traffic according to the fallback settings.
Click Apply.

To configure Transparent HA, do the following:

Select the Enable check box to configure the device to constantly be updated with TCP flow information.
Select a Partner Device to configure Transparent HA.
Select the Encrypt Traffic check box to protect network traffic between the devices, and enter and confirm the Passphrase.

To configure Zero Power HA, do the following:

If the TPS device does not have an installed bypass module, this option is not available.

Select Normal to configure the device to inspect traffic according to the TSE settings.
Select Bypass IPS to pass all network traffic regardless of the fallback configuration on each segment.
Click Apply.

Click OK.