Views:
This following table explains the minimum and recommended Encryption Management for Microsoft BitLocker system requirements.
Specification
Requirements
Processor
Intel Core 2 Duo 2.0 GHz processor or equivalent
RAM
Requirements are the based on Windows system requirements:
  • 64-bit systems: 2 GB
  • 32-bit systems: 1 GB
Disk space
  • 30 GB
  • 20% free disk space
Hard disk
  • Standard drives supported by Windows
Important
Important
Encryption Management for Microsoft BitLocker installation is only supported on endpoints with 1 physical hard disk drive (multiple partitions are supported).
Network connectivity
Connectivity with PolicyServer
Operating system
  • Windows™ 11 Enterprise and Professional editions (64-bit)
  • Windows™ 10 Enterprise and Professional editions (32-bit/64-bit)
Other software
  • Trusted Platform Module (TPM) 1.2 or higher
  • Full Disk Encryption is not installed
  • Microsoft .NET Framework 3.5
WARNING
WARNING
Full Disk Encryption is unable to install on SED disks attached to devices using UEFI if these disks were previously managed by Windows Bitlocker. To install Full Disk Encryption on these disks, perform one of the following:
  • Configure Full Disk Encryption to use software-based encryption by adding the FORCESOFTWARE parameter during installation.
    For details, see the Installing the Full Disk Encryption Agent section in the Endpoint Encryption Installation Guide.
  • Restore the SED disk back to its factory setting. This procedure removes all existing data from the SED disk. After the disk has been restored, try running the installer again.
Keywords: Seagate DriveTrust drives,system requirements,supported operating systems,Encryption Management for Microsoft BitLocker,hardware based encryption,OPAL