Configuring Time Zone and NTP Settings

Views:

Configure time zone and NTP server settings immediately after initial deployment.

Note

You must use NTP for time synchronization. You cannot manually configure the date and time on the Deep Discovery Director - Network Analytics appliance.

Procedure

From the Deep Discovery Director management console, access the Settings screen.
Accessing the Settings Screen
Go to System Settings → Time.
In the Date and time section, enter up to four NTP server addresses as IP addresses or FQDN.
Select the applicable time zone.

Note

Daylight Saving Time (DST) is used when applicable.
Select the preferred date and time format.
Click Save.

Keywords: configuring time zone and NTP settings from the,configuring settings for,time zone and NTP settings,configuring time zone and NTP settings