|
Enable IPSec
connection
|
Select ON to enable
the tunnel.
|
|
Name
|
Type a name to identify the IPsec VPN
tunnel.
|
|
Interface name
|
Select the interface name from the drop-down
list.
|
|
Gateway
|
Select the desired method for specifying the
gateway:
IP address: Specify
the gateway IP address.
Gateway name: Select
an available gateway from the drop-down list.
Note:
You can select either IP
address or Gateway
name if the VPN device is Cloud Edge. If the
VPN device is a third-party device, you must choose
IP address.
|
|
Local ID
|
Enter a text string for Local
ID. Cloud Edge uses the
Local ID to help identify
which gateways are local in the topology.
|
|
Remote ID
|
Enter a text string for Remote
ID. Cloud Edge uses the
Remote ID to help identify
which gateways are remote in the topology.
|
|
Add local
networks
|
Select the local network or add a new address
object.
|
|
Add remote
networks
|
Select the remote network or add a new
address object.
|
|
Authentication
type
|
Select Preshared key
or RSA key from the drop-down
list.
|
|
For Preshared key
|
Specify the key and confirm it.
If Preshared Key is
selected, specify the pre-shared key in
Key and confirm it in
Confirm key. Cloud Edge uses the
key to authenticate itself to the remote peer or dial-up
client. Make sure to define the same value at the remote
peer or client. The key must contain at least six
printable characters and should be known only by network
administrators. For optimum protection against currently
known attacks, the key should consist of a minimum of 16
randomly chosen alphanumeric characters.
|
|
Policy name
|
Select the policy name from the drop-down
list, either Default or a
specific policy, that applies to the IPsec tunnel.
|
