Views:
This section describes firewall settings. Be sure to configure your firewall correctly before you install ServerProtect components.
  • Firewall Setting for the Machine with Management Console
    • Open 1000 - 1009 port for TCP protocol
      1000 - 1009 is used by the Management Console to receive the event response message from the Information Server.
      The Management Console will listen to port 1000 during startup. If the port is occupied by a certain program, the Management Console will find one available port from 1001 - 1009.
  • Firewall Setting for Information Server
    • Open 5005 – 5014 ports for TCP protocol.
      Port 5005 is used to receive commands from the Management Console. Normally, port 5005 must be opened. If it is used by a certain program, please find one available port from 5006 - 5014 and open the firewall.
    • Open 3000 - 3009 for UDP protocol
      Port 3000 is used to receive broadcast messages. If port 3000 is occupied by a certain program, please find one available port from 3001 - 3009 and open the firewall.
    • Open 137 - 139 and 445 for RPC Over named pipe
      • 137 (UDP)
      • 138 (UDP)
      • 139 (TCP)
      • 445 (TCP)
      Note
      Note
      These ports are opened to enable ServerProtect to use Remote Procedure Call (RPC) Over named pipe protocol to communicate.
    • Open 3628(TCP)
      Port 3628 is used to receive event response messages.
    • Open 1921 for SPX/TCP with Netware
      Port 1921 is used to communicate with Netware through the SPX/TCP protocol.
  • Firewall Setting for Windows with Normal Server
    • Open 5168 for listening RPC over TCP/IP from Information Server
      Port 5168 is used to receive commands from Information Server.
    • Open 137 - 139 and 445 for named pipe.
      • 137 (UDP)
      • 138 (UDP)
      • 139 (TCP)
      • 445 (TCP)
  • Firewall Setting for the Netware Machine with Normal Server
    • Open port 9921 (SPX/TCP)
      This port is used to receive commands from Information Server.