You can use the Storage Maintenance screen to specify the cluster node to store analysis results and control the amount of logs that Deep Discovery Analyzer saves.
- Go to Administration > System Maintenance and click the Storage Maintenance tab.
-
In the Analysis Results section, select the node location to store analysis
results.
-
Primary node: Select this option to store all analysis results (for samples analyzed on both the primary and secondary nodes) on the primary node
Note:Selecting this option may increase storage utilization on the primary node.
-
Primary and secondary nodes: Select this option to store analysis results on the node that scanned the sample. For example, if a sample is analyzed on a secondary node, the result is stored on the node itself and is not sent to the primary node.
Note:You can view the data backup status for secondary nodes on the Data Backup screen.
-
-
In the Detection Logs section, configure the following settings:
-
Delete logs older than: Specify the number of days to keep logs
Note:The specified value must be between 1 and 100.
-
Delete logs when the total free disk space is lower than: Specify the disk space threshold for automatic log deletion and select the type of logs to delete (all logs or prioritize log deletion based on detection risk)
Note:-
The threshold value must be between 10 and 90.
-
Deep Discovery Analyzer purges 10% more than the specified percentage.
-
If you select Delete logs for non-malicious sample detections first, system performance may be affected since Deep Discovery Analyzer checks and deletes one log at a time.
-
-
- Click Save.