Purpose: Add endpoints to the protection list for WFBSS Endpoint Protection.
Location: Gateways > (gateway name) > NETWORK ACCESS CONTROL > WFBSS Endpoint Protection > General

Procedure

  1. Add endpoints to the Protection List.
    1. In the Protection List section, click Add.
      The Add Protection screen opens.
    2. Add endpoints to the protection list by specifying the following:
    Option Description
    Name
    Specify a name that helps you identify information about this entry.
    Example: JSmith
    Example: Office
    Address Type
    Choose either IPv4 or MAC.
    IP/MAC Address
    Enter the appropriate information according to the chosen type:
    • IPv4: Enter information as a comma-delimited list.
      Value can be a single IP address, an IP address range, or a CIDR.
      Example: 192.168.0.1,10.0.0.1-10.0.0.4,10.0.0.8/24
    • MAC: Enter a single MAC address
      Example: 00:FF:8A:B9:5A:49
      Example: 00-FF-8A-B9-5A-49
  2. Click Save.
  3. Continue adding endpoints to the protection list as needed.
    You can add up to a maximum of 256 entries to the protection list.