Purpose: Add endpoints to the exception list for WFBSS Endpoint Protection.
Location: Gateways > (gateway name) > NETWORK ACCESS CONTROL > WFBSS Endpoint Protection > General

Procedure

  1. Add endpoints to the Exception List.
    1. In the Exception List section, click Add.
      The Add Exception screen opens.
    2. Add endpoints to the exception list by specifying the following:
    Option Description
    Name
    Specify a name that helps you identify information about this entry.
    Example: JSmith
    Example: Office
    Address Type
    Choose either IPv4 or MAC.
    IP/MAC Address
    Enter the appropriate information according to the chosen type:
    • IPv4: Enter information as a comma-delimited list.
      Value can be a single IP address, an IP address range, or a CIDR.
      Example: 192.168.0.1,10.0.0.1-10.0.0.4,10.0.0.8/24
    • MAC: Enter a single MAC address
      Example: 00:FF:8A:B9:5A:49
      Example: 00-FF-8A-B9-5A-49
  2. Click Save.
  3. Continue adding endpoints to the exception list as needed.
    You can add up to a maximum of 256 entries to the exception list.