Adding a Static Route

Views:

When new IPv4 static routes are added, Cloud Edge checks whether a matching route and destination already exist in the Cloud Edge routing table. If no match is found, Cloud Edge adds the route to the routing table.

Note

Since Routing Mode does not support IPv6, you can configure only IPv4 static routes.

Procedure

Go to Gateways → (gateway name) → NETWORK → Static Routes.
Click Add to add a default route.

The Add/Edit Static Route window appears.
Select Enable static route.
In Destination network, specify the network address.

Any of the following options are valid:
- IP address
- Default gateway (Example: 10.10.10.10/16)
  
  Note
  
  If multiple default gateways are configured, outgoing traffic is routed from these gateways using round-robin selection.
- Bitmask
  
  Note
  
  The bitmask is the decimal equivalent of the netmask.
- Class InterDomain Routing (CIDR) notation (Example: 255.255.255.0/24)
In Nexthop, specify the next-hop IPv4 address.
Click Save.

Keywords: static route,adding