Connecting Network Sensors to a Service Gateway

Connect network sensors to a Service Gateway to use the Service Gateway as source for additional services.

Note:
  • At least one Service Gateway must be configured to enable this feature.

    For more information, see Service Gateway Inventory.

  • Make sure the services are enabled in the Service Gateway Settings.

    For more information, see Configuring Service Gateway Settings

  • For ActiveUpdate and Smart Protection Services, use the Service Gateway’s host name or IP address to configure settings on the network sensor’s console.

  1. On the Trend Micro Vision One console, go to Inventory Management > Network Inventory.
  2. Select one or more network sensors, and then click Connect Service Gateway.

    The Connect Service Gateway panel appears.

    Note:

    The Connect Service Gateway panel displays a list if any selected network sensors are already connected to a Service Gateway.

  3. Select a Service Gateway.
  4. Click Connect.

    The selected network sensors connect to the Service Gateway. View the Service Gateway status in the Network Inventory app.

    Important:

    Any networks sensors that were already connected to a Service Gateway will now use the specified Service Gateway as source for additional services.