Endpoint Encryption 6.0 Administration Guide > Getting Started > System Requirements > Encryption Management for Microsoft BitLocker System Requirements

Encryption Management for Microsoft BitLocker System Requirements

This following table explains the minimum and recommended Encryption Management for Microsoft BitLocker system requirements.

Specification	Requirements
Processor	Intel Core 2 Duo 2.0 GHz processor or equivalent
RAM	Requirements are the based on Windows system requirements: 64-bit systems: 2 GB 32-bit systems: 1 GB
Disk space	30 GB 20% free disk space
Hard disk	Standard drives supported by Windows
Network connectivity	Connectivity with PolicyServer
Operating system	Windows™ Embedded POSReady 7 (32-bit/64-bit) Windows™ 10 Enterprise and Professional editions (32-bit/64-bit) Windows™ 8.1 Enterprise and Professional editions (32-bit/64-bit) Windows™ 8 Enterprise and Professional editions (32-bit/64-bit) Windows™ 7 Enterprise and Professional editions (32-bit/64-bit)
Other software	Trusted Platform Module (TPM) 1.2 or higher Full Disk Encryption is not installed Microsoft .NET Framework 3.5 Windows BitLocker is disabled Warning: Full Disk Encryption is unable to install on SED disks attached to devices using UEFI if these disks were previously managed by Windows Bitlocker. To install Full Disk Encryption on these disks, perform one of the following: Configure Full Disk Encryption to use software-based encryption by adding the FORCESOFTWARE parameter during installation. For details, see the Installing the Full Disk Encryption Agent section in the Endpoint Encryption Installation Guide. Restore the SED disk back to its factory setting. This procedure removes all existing data from the SED disk. After the disk has been restored, try running the installer again.