Procedure

1. Navigate to Networked Computers → Client Management.
2. In the client tree, you can:
   • Click the root domain icon () to deploy the module to all existing and future clients.
   • Select a specific domain to deploy the module to all existing and future clients under the domain.
   • Select a specific client to deploy the module only to that client.
3. Deploy the module in two different ways:
   • Click Settings → DLP Settings.
   • Click Settings → Device Control Settings.

     Note If you deploy from Settings → DLP Settings and the Data Protection module was deployed successfully, Data Loss Prevention drivers will be installed. If the drivers are installed successfully, a message displays, informing users to restart their computers to finish installing the drivers. If the message does not display, there might be problems installing the drivers. If you enabled debug logging, check the debug logs for details about driver installation problems.

4. A message displays, indicating the number of client that have not installed the module. Click Yes to start the deployment.

   Note If you click No (or if the module was not deployed to one or several client for some reason), the same message displays when you click Settings → DLP Settings or Settings → Device Control Settings again.

   Clients start to download the module from the server.
5. Check if the module was deployed to clients.
   1. In the client tree, select a domain.
   2. In the client tree view, select Data protection view or View all.
   3. Check the Data Protection Status column. The deployment status can be any of the following:
      • Running: The module was deployed successfully and its features have been enabled.
      • Requires restart: Data Loss Prevention drivers have not been installed because users have not restarted their computers. If the drivers are not installed, Data Loss Prevention will not be functional.
      • Stopped: The service for the module has not been started or the target computer has been shut down normally. To start the Data Protection service, navigate to Networked Computers → Client Management > Settings → Additional Service Settings and enable Data Protection Services.
      • Cannot install: There was a problem deploying the module to the client. You will need to re-deploy the module from the client tree.
      • Cannot install (Data Loss Prevention already exists): The Trend Micro Data Loss Prevention software already exists on the endpoint. OfficeScan will not replace it with the Data Protection module.
      • Not installed: The module has not been deployed to the client. This status displays if you chose not to deploy the module to the client or if the client’s status is offline or roaming during deployment.