Procedure

1. Navigate to Networked Computers → Client Management.
2. In the client tree, click the root domain icon () to include all clients or select specific domains or clients.

   Note Check Point SecureClient Support does not support IPv6. You cannot deploy this module to pure IPv6 endpoints.

3. Click Settings → Privileges and Other Settings.
4. On the Privileges tab, go to the Toolbox Privileges section.
5. Select Display the Toolbox tab on the client console and allow users to install Check Point SecureClient Support.
6. If you selected domain(s) or client(s) in the client tree, click Save. If you clicked the root domain icon, choose from the following options:
   • Apply to All Clients: Applies settings to all existing clients and to any new client added to an existing/future domain. Future domains are domains not yet created at the time you configured the settings.
   • Apply to Future Domains Only: Applies settings only to clients added to future domains. This option will not apply settings to new clients added to an existing domain.