When a new endpoint registers to
Control Manager, it goes through
the filtered policies in the list in descending order.
Control Manager assigns the new
endpoint to a filtered policy when the following conditions are
both satisfied:
The same action applies to an endpoint already assigned to a
policy, but the policy creator later deletes the policy.
 |
Note
For endpoints just registered to Control Manager and for those just released
from deleted policies, there is a three-minute grace period during
which no endpoint allocation occurs. These endpoints are temporarily
without policies during this period.
|
If an endpoint does not meet the target criteria in any filtered
policies, the endpoint does not associate with any policies. Control Manager allocates these endpoints
again when the following actions occur:
-
Create a new filtered policy
-
Edit a filtered policy
-
Reorder the filtered policies
-
Daily endpoint allocation schedule
Control Manager uses a daily
endpoint allocation schedule to ensure that endpoints are assigned
to the correct policies. This action occurs once at 3:15 pm every
day. When endpoint properties change, such as the operating system
or IP address, these endpoints require the daily schedule to re-assign
them to the correct policies.
|
Note
If the endpoints are offline
during the daily endpoint allocation schedule, the policy status
for these endpoints will remain pending until they go online.
|
When the above actions occur, Control Manager allocate
endpoints based on the following conditions:
Endpoint Allocation
for Filtered Policies
| |
New endpoints or endpoints
from deleted policies
|
Endpoints without policies |
Endpoints with policies |
| Create a new policy |
|
 |
|
| Edit a policy |
|
|
|
| Reorder the filtered policies |
|
|
|
| Daily endpoint allocation schedule |
|
|
|
