Adding a Policy-based Route Parent topic

When the network traffic does not match any policy-based routing rule, the default gateway (static route to 0.0.0.0/0) applies to all traffic. To configure a default gateway, go to Adding a Static Route.
Tip
Tip
Trend Micro recommends configuring at least one default gateway.

Procedure

  1. Go to Network → Routing → Policy Routing.
  2. Click Add New.
  3. Optionally enable the rule.
  4. Specify a policy name between 1 and 32 characters, consisting of letters, numbers, or underlines.
  5. Type an optional Description.
  6. Under Source Addresses, select one of the following parameters:
    • Any: Includes all source addresses. (Default)
    • Selected addresses: Displays a list of previously configured source addresses available or to add a new IP address.
    Note
    Note
    To add new address objects, see Configuring Address Objects.
  7. Select the appropriate source interface from the drop-down box.
  8. Under Destination Addresses, select one of the following parameters:
    • Any: Includes all destination addresses
    • Selected addresses: Displays a selectable list of previously configured destination addresses to use. Use this option to add address objects, if needed.
    Note
    Note
    To add destination addresses, see Configuring Address Objects
  9. Under Service type, select one of the following parameters:
      • Any: Include all services
      • Selected: Include only selected services
  10. Select the egress interface.
  11. For interfaces with static IP addresses, specify the next hop.
  12. Optionally enable network masquerading.
    Note
    Note
    Enable network masquerade if internal IP address must be translated to the IP address of the egress interface.
  13. Click OK.