This section explains how to specify a range of IP addresses for PPTP clients
or configure the PPTP client-side IP address to be used in the tunnel setup.
Deep Edge supports Point-to-Point
Tunneling Protocol (PPTP) to tunnel PPTP traffic between two VPN peers. Windows or
Linux PPTP
clients can establish a PPTP tunnel with a Deep Edge that has
been configured to act as a PPTP server. As an alternative, configure Deep Edge to forward PPTP packets to a PPTP server on the
network behind the Deep Edge. PPTP VPN is available only in
NAT/Route mode. The current maximum number of PPTP sessions is 254.
When using Deep Edge as a PPTP gateway,
select a PPTP client IP from a local address range or use the server defined in the
PPTP user
group. Select which method to use for IP address retrieval and, in the case of the
user group
server, provide the IP address and the user group.
You must select the local user or LDAP for authentication at tab.
