Procedure

1. Log on to your Check Point appliance.

   

2. (Optional) Set a password for expert mode.
3. Type the password to enter expert mode.

   

4. Use the vi editor to open /var/opt/CPsuite-R80/fw1/conf/fwopsec.conf.

   

   Note The image of the default configuration is for reference only. The actual file contents may vary.

5. In fwopsec.conf, configure the SAM communication mode ports using one of the following options:
   • Secured connection (default port)
     • No changes in fwopsec.conf are necessary. The default port 18183 is used for the sam_server auth_port setting.

       Note On Deep Discovery Inspector, verify that the Check Point Open Platform for Security (OPSEC) Port setting at Administration → Integrated Products/Services → Inline Products/Services is also 18183.

   • Secured connection (user-defined port)
     • In fwopsec.conf, remove the comment sign (#) from sam_server auth_port: 18183 and then change the port number.

       Note Configure the same port in fwopsec.conf and in the Check Point Open Platform for Security (OPSEC) Port setting on Deep Discovery Inspector at Administration → Integrated Products/Services → Inline Products/Services.

   • Clear connection (user-defined port)
     • In fwopsec.conf, remove the comment sign (#) from sam_server port: 0 and then change the port number.

       Note Configure the same port in fwopsec.conf and in the Check Point Open Platform for Security (OPSEC) Port setting on Deep Discovery Inspector at Administration → Integrated Products/Services → Inline Products/Services.

6. If changes were made to the fwopsec.conf file, save the fwopsec.conf file and restart your Check Point appliance.